For all of those who want to do the Twin Pot brake conversion.....

What you will need
1. Twin pot calipers from a 2nd gen
2. Either Machined rotors or new ones (Preferred)
3. New pads for the twin pots
4. New brake hoses (will cover this later)
5. Some basic knowledge of what you are doing
6. Basic tools and brake bleeding bottle (will also cover this)

Pre Step
1. Get ABS to make you some new brake hoses (ABS are the only company who can make ADR compliant hoses) You will need the fitting off the ABS caliper end and on the other end the fitting of your non abs hose.
2. To make a bleeding bottle, use a 600ml PET bottle, drill a hole in the lid and feed through some vacuum hose to the bottom of the bottle. Drill a breather hole (1/8th) near top. Grab an old coat hanger, cut it up and wrap around top of bottle to make a hanger for the bottle.

Steps
1. Raise front of vehicle on stands or hoist
2. Remove wheels
3. Remove brake hoses (drain fluid as does not hurt to replace fluid)
4. Remove caliper bracket from hub, lift entire assy away
5. Remove old rotor
6. Fit new rotor, make sure that hub is spotless (need to make sure step followed so as not to have rotor off center)
7. Remove new caliper from bracket, push both pistons in(don't squirt yourself in the face with fluid), clean slider pins and lube with rubber grease.
8. Fit bracket and torque
9. Use anti squeal on back of pads, little amount of graphite grease on the contact surface of pad (where sits on bracket)
10. fit pads
11. Fit caliper to bracket
12. Fit hoses

Now follow same for the other side.

To bleed brakes, make sure reservoir is full, attach bottle to one side, crack bleed nipple and slowly pump brake pedal. Keep an eye on fluid level, you will notice that the bottle fills and the hose will stop air back flowing into the brake system.

Once you have regained a good pedal, re fit wheels, torque nuts (not rattle gun) and then go for a drive to bed in brakes

I always recommend you test them in the driveway to ensure all is working well.

I will leave this thread open for questions however please ensure that your questions are relevant to the thread or they will be deleted